1/16/2024 0 Comments Qnap qfinder not finding nas 2017![]() ![]() May sure you have the latest Qfinder and do not have any firewall/antivirus blocking access on the PC. When connected direct you could have set a static address in the range of your network addresses. Try to start new threads than run on previous, your issue could be unrelated.Ĭan you see any IP address in the router that could be the NAS? But when I connect the 453 to the network again I can not see it on the network via qfinder. Bit late, but wanted to thank you regardless. ![]() QFinder is just a front to this interface. May have to enter login info, should show up. Then enter \NAS IP ADDRESS and select a drive letter.All OK as far as I can see - all HDDs on the list. Try mapping it directly: Go to Windows File Explorer This PC and click Map Network Drive. Hot-plug the working HDDs, then click the details button on QNAP Finder. Automatically finds and displays all QNAP NAS, switches, and routers on the same network. Using a direct cable connection from the device to PC directly, the PC need to change LAN card IP address to 169.254.100.101(submask set 255.255.0.0).Ĥ. Remove all the HDDs from the device, press the power button. I would be grateful for any suggestions as I have important data on the device that I am currently unable to access at all. I have tried Ethernet cable in both LAN ports. I am also not able to access the web interface at the IP Address. Also, I am using a regular RJ45 ethernet cable. If you are using QuFirewall make sure to add your computers IP address to the 'firewall profiles'. Add both your NAS and PC to the same subnet (which is what I was always doing). On the occasions where QFinder does detect it, I am unable to execute any commands as it states the device is unreachable (or requests a login when I try to upgrade firmware and will not accept the admin/admin credentials which have not changed). Found Solution: This is for anyone looking for this answer. Have tried rebooting anything and everything. I have tried Fixed mapping to both of these IP addresses on my router to no avail. More often that not it is just not detected at all - all lights indicate connectivity for LAN is fine. If you do not see the NAS in Finder, check your desktop. Qnap Port Trunking, Qnap Load Balance, Qnap Wireless connection. Thank you for the offer to connect remotely to my computer. Pinging 192.168.20.3 with 32 bytes of data: If you do not see the NAS there, follow these steps: Click on Finder in the top left hand corner of your screen. My router sees it on IP 192.168.20.3 (used to be 192.168.20.4) and on occasion I can ping the device with a response. To enable this service, go to Control Panel > Network & File Services > Service Discovery and in the tab UPnP Discovery Service, you may enable the UPnP Discovery service to address this issue. I have usually been able to get around this by restarting the device but now I am unable to see it on the network at all. This issue could be caused, because UPnP discovery service is disabled. TS-451 QNAP has been intermittent with dropping off the network and not being visible in File Exlorer (Network) or QFinder. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |